1/48 Wings Atlas D Update 5

Before starting the main turbopump exhaust I decided to add the enclosure and braces for the fuel fill and drain line. I began by adding a triangular piece on either side of the existing drain line mount point. I made them from .010" sheet styrene. I next added a top piece and shaved down the … Continue reading 1/48 Wings Atlas D Update 5

1/48 Wings Atlas D Update 4

To get ready to open the center heat shield I did a rough measurement and then used a grinding bit to open the shape. In the photo above, the protrusion on the left is for the turbopump exhaust that is on the center nozzle. I opened up the heat shields. I started by drilling a … Continue reading 1/48 Wings Atlas D Update 4

1/48 Wings Atlas D Update 3

While studying the model and what I had done with the stringers on the capsule adapter, I decided that I had to fix the stringers on the boat tail. I sanded down the molded in stringers on one side of the part. I was able to sand down all the raised parts without much trouble. … Continue reading 1/48 Wings Atlas D Update 3

1/48 Wings Atlas D Update 2

I took some time off from the capsule adapter to drill out the fuel fill and drain pipe. Above is a photo. There were two in the kit, but only one is needed for the model. I put them side by side to show the difference after drilling. Apparently the adapter is still just a … Continue reading 1/48 Wings Atlas D Update 2

1/48 Wings Atlas D Update 1

The angular details on the sustainer nozzle are looking much better. Not quite finished yet, but looking better. There are still a bazillion holes all over the molding. Those are going to be a pain. You can see from the opening photo, that I have also sanded off all the molded in stringers on the … Continue reading 1/48 Wings Atlas D Update 1