1/48 Wings Atlas D Update 2

I took some time off from the capsule adapter to drill out the fuel fill and drain pipe. Above is a photo. There were two in the kit, but only one is needed for the model. I put them side by side to show the difference after drilling. Apparently the adapter is still just a … Continue reading 1/48 Wings Atlas D Update 2

1/48 Wings Atlas D Update 1

The angular details on the sustainer nozzle are looking much better. Not quite finished yet, but looking better. There are still a bazillion holes all over the molding. Those are going to be a pain. You can see from the opening photo, that I have also sanded off all the molded in stringers on the … Continue reading 1/48 Wings Atlas D Update 1

1/48 Wings Atlas D

My next model build is a 1/48 scale Atlas D rocket by Wings48. I bought this kit back in 2005 from Don's Model Works who was producing the kit lines by Wing48, Wings72. This kit was originally produced by Eagles Talon Models. The Don had aquired the Wings48 and Wings72 lines a couple of years … Continue reading 1/48 Wings Atlas D

1/48 Mercury Redstone Part 7, Finish

I assembled the launch stand and painted it TS-83 Gun Metal and over coated with Flat Clear. Just as I was about to start painting the propellant section, I realized that my scratch built fill/drain/vent ports were in the wrong place. I put the LOX vent where the LOX fill and drain was supposed to … Continue reading 1/48 Mercury Redstone Part 7, Finish

1/48 Mercury Redstone Part 6

Work continues on the Redstone. I added the turbine exhaust port to the bottom of the propulsion section. I created it with some 1/8 inch tubing and cut a slice out of the side of it to make the diameter shorter so it would fit in the smaller hole of the turbine exhaust. After inserting … Continue reading 1/48 Mercury Redstone Part 6