Tag: Redstone

1/72 Mercury Redstone Part 1

The next part of this build will be the 1/72 scale kit from Horizon Models. I've built their Mercury kit before. You can see that build here. It is a good kit for its scale. There are, of course, some detail problems with the Mercury capsule, but it does build up into a nice model. … Continue reading 1/72 Mercury Redstone Part 1

1/48 Mercury Redstone Part 7, Finish

I assembled the launch stand and painted it TS-83 Gun Metal and over coated with Flat Clear. Just as I was about to start painting the propellant section, I realized that my scratch built fill/drain/vent ports were in the wrong place. I put the LOX vent where the LOX fill and drain was supposed to … Continue reading 1/48 Mercury Redstone Part 7, Finish

1/48 Mercury Redstone Part 6

Work continues on the Redstone. I added the turbine exhaust port to the bottom of the propulsion section. I created it with some 1/8 inch tubing and cut a slice out of the side of it to make the diameter shorter so it would fit in the smaller hole of the turbine exhaust. After inserting … Continue reading 1/48 Mercury Redstone Part 6

1/48 Mercury Redstone Part 2

With the tower legs cleaned up, I started on the other nose parts. The nose cap was masked and then primed and then painted with Tamiya TS-14 Black. I then used some MicroScale MicroMask to cover the painted part. This will protect it when the tower is painted red later on. Once the red is … Continue reading 1/48 Mercury Redstone Part 2