1/144 Saturn I Block II SA-5 Build Update 7

It's been a while, time for an update on the SA-5 build. There are quite a few details that need to be added to the S-IV and interstage areas. But before that I needed to add the payload section to the S-IV interstage. There are a lot of details that go on the S-IV interstage … Continue reading 1/144 Saturn I Block II SA-5 Build Update 7

1/144 Saturn I Block II SA-5 Build Update 6

Progress continues on the SA-5 model. I made the decision to replace the S-IV that came in the upgrade kit with my own that I would make out of some resin that I already had. This would give me a round S-IV stage that would match the interstage without massive amounts of filler and hours … Continue reading 1/144 Saturn I Block II SA-5 Build Update 6

1/144 Saturn I Block II SA-5 Build Update 5

A little more work on the S-I stage. First I took out my Dremel and thinned the walls of the eight H-1 engines. The kit engines have nozzle walls that are far too thick. The picture doesn't show it well but the walls are much thinner that before. Next I glued on the stub fins … Continue reading 1/144 Saturn I Block II SA-5 Build Update 5

1/144 Saturn I Block II SA-5 Build Update 4

Here is a quick update of the SA-5 progress. I glued on the antennas, the umbilical door, and the hydrogen vent pipes. The umbilical door is cut from .005 sheet stock while the antennas are cut from some strip stock I had that looked close. The hydrogen vent pipes look a bit different that the … Continue reading 1/144 Saturn I Block II SA-5 Build Update 4

1/144 Saturn I Block II SA-5 Build Update 3

Back to work on the SA-5 model a bit. Work continues on the S-I first stage. I got the puttying and trimming on the tanks done and they should be pretty smooth. I scratch built the gaseous hydrogen vent pipes that go down the first stage at three points. There was plastic rod included in … Continue reading 1/144 Saturn I Block II SA-5 Build Update 3